Initialisation; Set-Up (Example); Recorded Messages - Telecom Behnke 20-3117 Mode D'emploi

3.2. Initialisation

Once the telephone line is connected, the door
intercom starts initialisation. During the initial-
isation the telephone line will be busy, and a
high-pitched tone will be sent. Afterwards, the
door intercom will hang up and will be ready for
set-up.
In case the device produces regular tone
sequences, call the beeps and consult the basic
electronics manual to check the possible fault.

3.3. Set-up (example)

* beep 0 0 0 0 beep beep
2 1 telephone no. #
beep beep
2 2 beep beep telephone no. #
...
*
Start set-up mode by entering *0000 and then
enter the following parameters:
21 telephone no. Key 1 #
... telephone no. Key ...#
28 telephone no. Key 8 #
10 Code to open door #
For additional parameters, please see the
technical user manual or the analogue base
electronics manual and enter them accordingly.
www.behnke-online.com
Commissioning with analogue basic electronics Commissioning with analogue basic electronics
beep beep
beep
Press the * key to end set-up mode. The set-up
can also be performed with an analogue tele-
phone with DTMF dialling. Please see the basic
electronics manual.

3.4. Recorded messages

The door intercom can play recorded messages
when a call button is pressed. You will have
to record these messages previously. Use the
configurations step 51-58 as described in the
technical user manual. Please find a couple of
examples for these messages below:
1 ▸ Establishing connection.
2 ▸ Please wait.
3 ▸ Connection established.
4 ▸ The door will open.
5 ▸ Please enter the code and confirm your
entry with the # key.
6 ▸ This is a call from your door intercom. Please
enter zero pound to open the door.
Special needs Manual
GB
35 35