Telecom Behnke 20-3117 Mode D'emploi page 44

Special needs Manual
GB GB
Commissioning with analogue basic electronics
Code Parameter
Voice message and speed dial function: Default setting: 0
57 0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
This configurations step allows you to determine a voice message to be played
when the speed dial function is in use. The message will be played until you
start entering the two digit speed dial number on the keypad.
Voice message during a direct call function: Default setting: 0 0 0
58 x [beep] y [beep] z [beep]
x = Voice message before the direct call is dialled
y = Voice message while waiting for the call to be picked up
z = Voice message after the called party has picked up. The following entries
are permitted for x; y and z:
0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
Via this configuration step, you may set up to 3 voice messages to be played
during a direct call (dialling of a number previously stored in the device).
During this configuration step, the device requires the entry of 3 digits from
0 to 9 to specify the voice message to be played. The first cypher determines
the voice message to be played prior to dialling the telephone number, e.g. a
message like "Direct call activated".
The second cypher determines the voice message to be played repeatedly
while the connection is being established, e.g. a message like "Please hold the
line." The third cypher determines the voice message to be played upon picking
up by the called party. The message will also only be played to the called party,
e.g. a message like "Call from your intercom system." or information with
regard to the caller's position when used as an emergency phone.
44
Confir-
mation
#
#
:
#
#
www.behnke-online.com