Set-Up Example - Telecom Behnke 20-3117 Mode D'emploi

5.3. Set-up example

In this example, the intercom buttons are located on the multi-key electronics circuit (pin header or
screw terminals connected).
Relay 1 (here: door opener) is activated for 10 seconds. The relevant pictograms are triggered during
events.
After making a choice, a voice message is played for the person waiting and one is played for the
person answering the call after it has been accepted.
(40-0006 (Basic electronics- triphone), 40-0007, 40-0008, 40-0013 as well as 20-0061 (function
without 20-0061 not possible)
*0000
51 1# Record voice message for the person waiting (cf. technical manual or chapter „Most
important configuration steps" on page 37)
51 2# Record voice message for the person answering the call (cf. technical manual or chapter
„Most important configuration steps" on page 37)
301 telephone no. Key 1 *812
(with voice message for the person waiting/
the person answering the call) # ▸ Enter the telephone no. for the 1st Key
:
399 Telephone number Key 99 *812
(function waiting for the call to be answered
(function waiting for the call to be answered
(with voice message for the person waiting /
the person answering the call) # ▸ Enter the telephone no. for the 99th Key (depending on
09 10 #
10 0 #
*
www.behnke-online.com
Connection to triphone basic electronics
▸ Enter set-up mode
the amount of the connected key and the connection
position of the multi-key connection circuit (1-25) (26-50)
(51-75) (76-100 (set-up 300 corresponds to key 100))
▸ set the open door time interval (5 to 90 seconds)
▸ Set 0 as the code to open the door
▸ Exit set-up mode
Special needs Manual
GB
53