Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.7. Set-up example with group call function without voice messages with one
call button and 3 goals to be achieved
*0000
20 3#
21
22
23
09 10#
10 0#
900 1#
979 1#
*
3.8. Most important configuration steps
Code
Parameter
Group call / Eavesdropping protection / Captive call / EN 81-28/70 operation:
Default setting: 0
20
0 = inactive (group call, eavesdropping protection and captive call inactive)
1 = dial telephone number 1 (eavesdropping protection and captive call)
2 = dial telephone numbers 1 to 2 (eavesdropping protection and captive call)
:
8 = dial telephone numbers 1 to 8 (eavesdropping protection and captive call)
9 = dial telephone numbers 1 to 9 (eavesdropping protection and captive call)
When group calling is active and any direct dial key (except for the i key) is
pressed, the respective telephone numbers (1 to x) are dialed successively
until someone is reached who can properly acknowledge the receipt with any
DMTF tone or until all telephone numbers have been dialed. For x=9, the i key
is also dialed during the group call, otherwise telephone number 9 is dialed
when pressing the i key. After V1.61, the call is not ended after expiry of the
confirmation time when making a group call consisting of more than one tele-
phone number (configuration step 20 to 1), the connection will remain without
confirmation.
www.behnke-online.com
Commissioning with analogue basic electronics
▸ Enter set-up mode
▸ Group call function
▸ 1. Telephone number #
▸ 2. Telephone number #
▸ 3. Telephone number #
(Configuration steps from page 37)
▸ set the open door time interval (5 to 90 seconds)
▸ Set 0 as the code to open the door
Enables advanced configurations
Group call confirmation (conf. 20) by answering the call.
(Not possible for groups of extensions in the telephone
system)
▸ Exit set-up mode
Special needs Manual
Confir-
mation
#
#
#
:
#
#
GB
37
Publicité
Chapitres
Table des Matières
