Housing Board Description; Connection Of The Camera And Motorised Lens - Videotec ULISSE Manuel D'instructions

7.7 Housing board description

BOARD DESCRIPTION
Connector/Terminal Function
CN1 Not used
CN2 Motorised lens motor control
connector
CN3 Motorised lens potentiometer
connector
CN6 Not used
CN7 Camera power supply, additional
lines
DIP1 Select the lens power supply
voltage
Tab. 1
CN3
CN2
CN1
DIP1
Fig. 9
16
7.7.1 Connection of the camera and
motorised lens
All connections illustrated below should
be made only and exclusively by expert
installers who should comply with all the
wiring and power supply specifications for
the devices.
The electronics board is designed to control cameras
with motorised lenses (Focus, Iris, Zoom), which
may or may not have potentiometers to control the
position reached.
Before making the connections make sure that the
voltages supplied by the board fall within the limits
allowed for the apparatus.
CONNECTOR FOR CAMERA/MOTORISED LENSES
Voltage
+12V
+5V
From 6Vdc up to
CN6
15Vdc (adjustable)
CN7
Tab. 2
Lenses with common wire motors: Implement the
connections, as shown in the figure..
To power the camera perform the connections as
shown in figure.
Fig. 10 CN2.
+12V GND
Fig. 11
CN7.
Current Description
800mA max Camera power
supply
15mA max Lens potentiome-
ter power supply
200mA max Lens motor power
(Focus+Zoom+Iris) supply
+
FOCUS +
M
FOCUS -
+
M
IRIS +
IRIS -
+
ZOOM +
M
ZOOM -
CN2
+12V
GND
A
B
F1
F2
MNVCUPT3_1511_EN