Door Level Adjustment - Napoleon HIGH COUNTRY NZ7000 Instructions D'installation Et D'opération

6.2

DOOR LEVEL ADJUSTMENT

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the
appliance manufacturer.
Door adjustment may be
necessary if door is not level.
NOTE : Door adjustment is
strictly trial and error; you
may need to perform this
adjustment a few times until
the desired door angle is
attained.
1
Lower the door and shim the corner that is
resting on the hearth approximately half the gap
of the opposing side.
!
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
WARNING
56.1C
2
Loosen top and bottom screws on the left side
of door frame. Pull the high side down to touch
25
the hearth.
W415-1676 / A / 03.17.17
EN