Finishing Material - Napoleon HIGH COUNTRY NZ7000 Instructions D'installation Et D'opération

5.1

FINISHING MATERIAL

FACE MUST HAVE A
MIN. 8' (2.4M) HEIGHT
OF NON-COMBUSTIBLE
BOARD DEPENDING
UPON THE CEILING
HEIGHT
COMBUSTIBLE
FACING AND WOOD
FRAMING MAY
START AT 8' (2.4M)
ABOVE THE BASE OF
THE APPLIANCE.
NON-COMBUSTIBLE
BOARD FROM THE SIDE
MEASURED FROM THE
SIDE OF THE FACEPLATE.
WARNING: Screws used to fasten finishing materials to the face of the appliance above the guillotine
screen and door must not penetrate more than 1/2" (13mm) into the sheet metal front panels. Refer to
the "DIMENSIONS" section for specific requirements.
NON-COMBUSTIBLE BOARD
FACEPLATE
6" (152mm)
46 3/8"
(117.8cm)
MIN. ENCLOSURE
CEILING HEIGHT 96"
USE METAL STUDS WHEREVER
NON-COMBUSTIBLE FACING IS REQUIRED
21
(243.8CM).
W415-1676 / A / 03.17.17
EN