Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
!
•
Risk of fi re!
•
Never obstruct the front opening of the appliance.
•
The front of the appliance must be fi nished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specifi ed dimension, as illustrated.
•
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
•
Facing and/or fi nishing material must never overhang into the appliance opening.
•
The glass door assembly is a safety device designed to pivot forward when relieving excess pressure that
might occur. Finishing or other materials must not be located in the opening surrounding the door as this will
interfere with the doors ability to relieve pressure.
•
If applicable, drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must
be taken to prevent drywall dust from coming into contact with the blower or its compartment. Any damage
resulting from this condition is not covered by the warranty policy.
5.1
safety screen installation and removal
WARNING
!
•
Glass may be hot. Do not touch glass until cooled.
•
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
•
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and must be installed.
Open the side panels and control door on the appliance. Place the safety screen onto the door frame. Install the
4 screws on the top and bottom of the safety screen. Ensure the safety screen is installed correctly before closing
the side panels and control door. Reverse these steps to remove the safety screen.
1
3
45.1
2
4
5.0 finishing
47.2
W415-4005 / A / 07.22.21
EN
27
Publicité
Chapitres
Table des Matières
Dépannage
