Pause Mode ( ) - RS Pro RS-660 Manuel D'instructions

Logging Personal Noise Dosimeter / EN
In the pre-difined setup mode, press
customized configuration from "USER-1" to "USER-9" then press
to confirm. Press
parameters press
desired parameters value and press
When all parameter configuration is finished, press
8-5 Pause Mode (
Enable the pause mode so that you may temporarily stop a measurement run, for
example, during the worker's break. During a pause, all data is recorded.
Cumulative values will represent the measured data and will exclude the paused
intervals.
22
, keys to review the parameters, if you will change the
key to confirm then press
)
 (
( key)
( key)
, keys to select the desired
key again to save.
( key)
key)
, keys to change the
key to exit.
( key)
05/24/18 Version No. 00
key