Charging The Meter; Charging - RS Pro RS-660 Manuel D'instructions

Logging Personal Noise Dosimeter / EN
6.

CHARGING THE METER

6-1 Charging

The meter use internal Lithium polymer battery. Ensure the meter is fully charged
prior to use by placing in the charger. Note the meter will fit into charger unit
regardless of which mounting clips are attached.
Ensure the AC adapter is connected and the supply is switched on. The meter will
automatically switch on and display how much charge is within the meter. After
approximately 20 seconds the display will blank. Pressing either the
key will wake the display for a further 20 seconds to check progress. When the
meter is charging the red LED will on. The meter will display "FULL" once
charging is complete and the LED on the front of the meter will turn purple.
The LCD display
when the meter is on
and put on the
battery charger.
The LCD display
when the meter is
off and put on the
battery charger.
10
, or
05/24/18 Version No. 00