Smoke Chamber Insulation Panel Replacement - Napoleon High Country 7000 Mode D'emploi

6.7

smoke chamber insulation panel replacement

note:
For clarity purposes, some parts of the appliance have been hidden. The illustrations below are of views
looking up into the smoke chamber.
2
Back of appliance
A.
Remove screws from brackets and slide rear
panel (1) out of smoke chamber. Repeat for
both side panels (2, 3) (FIG.1).
note:
To ease installation, we recommend loosely installing the side and front panel brackets in place then installing
panels and tightening fasteners to secure.
D. Slide top panel into smoke chamber and Install the 4 brackets removed in Step C. (FIG.3)
E. Slide front upper panel into smoke chamber then front lower panel and install brackets. (FIG.2)
F. Slide side panels then rear panel into smoke chamber and install brackets. (FIG.1)
note:
Smoke chamber insulation panels are fragile. Handle with care.
3
1
FIG.1
Front of appliance
C. Remove screws from lower side brackets
and remove the side upper panels
(FIG.3 )
operation and adjustments
6
4
Front of appliance
B. Remove screws from lower brackets and
remove front lower panel (4, 5). Then
remove screws from upper brackets (6, 7)
and remove front upper panel (FIG.2).
FIG.3
EN
7
5
FIG.2
33
W415-1676 / D / 03.02.20