Troubleshooting - Napoleon High Country 7000 Mode D'emploi

11.0

troubleshooting

troubleshooting
EN
WARNING
!
• Turn off the appliance completely and let cool before servicing. Only a qualifi ed service person should service
and repair this electric appliance.
• Appliance may be hot, do not service until appliance has cooled.
• Do not use abrasive cleaners.
• When checking connections, installing jumper wires (for test purposes only) or replacing components, unplug
appliance from the receptacle to prevent electrical shock or damage to the component.
SYMPTOM
Smoke enters the room
during start-up.
Smoke enters the room
while re-loading.
NOTE: Open doors slow-
ly to allow pressures to
balance before opening
doors completely.
Appliance smoking.
46
W415-1676 / D / 03.02.20
PROBLEM
Damper in closed position.
Cold air blockage in chimney
Close the doors.
Damper in closed position
Insuffi cient draft.
Damper in closed position
Chimney cold
Inadequate supply of combus-
tion air
The outside air damper
opened.
The smoke passage is blocked
in the appliance or chimney.
The smoke fl ow impeded by
too long of a horizontal pipe or
too many bends.
A weak draft perhaps caused
by a leaky chimney, a cold out-
side chimney, too short a chim-
ney, or a chimney too close to a
tree or a higher roof.
TEST SOLUTION
- Open damper.
- Burn a piece of newspaper to establish a draft.
- Open outside air control damper.
- Open damper.
- Chimney height and outside conditions can negatively
affect draft. In these cases a small amount of smoke may
enter the home. Adding more pipe or a draft-inducing cap
may help.
- Clean chimney
- Open damper.
- Burn a piece of paper to establish a draft, fuel as
necessary to establish a hot fl ame.
- Chimney height and outside conditions can negatively
affect draft. In these cases a small amount of smoke may
enter the home. Adding more pipe or a draft-inducing cap
may help.
- Close damper.
- Check chimney for blockage and clear if necessary.
- Refer to "typical chimney installation" section for proper
chimney bends.
- Chimney height and outside conditions can negatively
affect draft. In these cases a small amount of smoke may
enter the home. Adding more pipe or a draft-inducing cap
may help. Refer to "typical chimney installation" section for
proper chimney bends.