Electrical Safety; General Safety - Franklin Electric FTB1CI Manuel Du Propriétaire

ELECTRICAL SAFETY

C A U T I O N
Make sure all ELECTRICAL POWER IS
OFF before connecting any electrical wires.
W A R N I N G
Capacitor voltage may be hazardous.
To discharge motor capacitor, hold insulated handle
screwdriver BY THE HANDLE and short capacitor
terminals together. Do not touch metal screwdriver blade
or capacitor terminals or electrical shock could occur. If
in doubt, consult a qualified electrician.
WA R N I N G
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
C A U T I O N
DO NOT touch an operating motor. The
surface of the motor may be HOT. Allow the motor to
cool for thirty (30) minutes before handling.
W A R N I N G
If power cord suffers damages, consider
this product does not allow partial replacement and
therefore should be fully replaced.
HP
1
1.5
2
3
5
115/230 V
Wire motor for correct
voltage. See "Electrical
Installation" section of this
manual and motor nameplate.
Ground motor
before connecting to
power supply.
Meet National Electrical
Code (NEC) or Canadian
Electrical Code(CEC) and
local codes for all wiring.
Follow all pump wiring
instructions provided in
this manual.
W W
1φ 3φ
1430 -
1970 -
2780 -
2830 1600
4740 2860
Thermal Protection
W

GENERAL SAFETY

• Do not allow pump or any system component to
freeze. To do so will void the warranty.
• This pump has been evaluated for pumping water
only. Pumping liquids other than water
may void warranty.
• Periodically inspect pump and system components.
INTRODUCTION
You have purchased one of the most user friendly
pumps available. The Turf Boss pumps are made with
high quality materials which are designed to provide
you with years of reliable service. Lawn sprinklers are
designed to maximize output flow, while still maintaining
the ability to draw water from a source up to 25 feet
below the pump. All mechanical parts, motor, impeller,
electrical controls, etc., are above ground within easy
reach. If service is ever necessary, simple hand tools will
do the job. This lawn sprinkler pump installs easily and
quickly without the need for special tools or pump rigs.
You can install it yourself provided you follow closely the
instructions contained in this manual.
INSPECT YOUR SHIPMENT
All Turf Boss lawn sprinkler pumps are carefully tested,
inspected, and packaged to ensure their arrival in perfect
condition. When the pump is received, examine it closely
to make sure there is no damage or broken parts that
may have occurred in shipping. If damage is evident,
report this immediately to your shipping carrier and
dealer. This shipping carrier assumes full responsibility
for the shipment's safe arrival. Any claim for damage to
the shipment, either visible or concealed, must be made
through the shipping carrier first.
PRE-INSTALLATION CHECK
• Pump must not be more than 25 feet above the
surface of the water.
• Use as few elbows and fittings as possible to reduce
friction and maximize flow.
• Be sure pipe, fittings, and foot valve are clean and
free of debris.
• There should be no air pockets or leaks in the suction
pipe.
• PTFE tape should be used to seal threaded pipe
connections.