Publicité
Getting Connected and Installing Drivers (Macintosh)
Installing the OS-standard driver
1
With the UA-700 disconnected, start up Mac OS.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
fig.05-35e_30
3
After starting up Mac OS, select
Apple System Profiler from the
Apple menu.
The "Apple System Profiler"
dialog box will appear.
4
Click the Devices and Volumes tab.
5
Use the USB cable to connect the UA-700 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
UA-700.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the UA-700 to your computer.
fig.advance-on
6
Set the UA-700's ADVANCE (mode select)
switch to the ON position.
7
Set the UA-700's power switch to the ON position.
8
Wait for approximately five seconds.
The UA-700 will use the driver included with Mac OS.
While you are waiting, the screen display will not change, but the UA-700 is
being detected. Do not touch the mouse or keyboard.
48
Once the connections
have been completed,
turn on power to your
various devices in the
order specified. By
turning on devices in the
wrong order, you risk
causing malfunction and/
or damage to speakers
and other devices.
Advance mode is
ON
This unit is equipped
with a protection circuit.
A brief interval (a few
seconds) after power up is
required before the unit
will operate normally.
Publicité
Chapitres
