Publicité
Names of things and what they do
Main control
fig.04-12
1
4. Power indicator
When you turn on the power switch, this indicator will blink for several seconds, and then remain lit.
5. Output level indicator
The number of LEDs that blink changes in accord with the output level, adjusted using the
MASTER knob. If the red LED at the far right lights, use the master knob to lower the volume.
6. Master knob (MASTER)
This adjusts the final overall volume. It controls the volume of the digital output jacks,
headphone jack, master output jacks (phone type), master output jacks (RCA phono type),
coaxial digital output jacks, and optical digital output jacks.
I Input monitor section
fig.04-10
1
2
"thru-ed" within your computer, or if you have connected a mixer and are outputting the input
signal directly from your mixer for monitoring. The volume you adjust here will not affect the
recording level.
* The input monitoring on/off state can be controlled directly from an ASIO 2.0 compatible application such
as Cubase.
2. Input monitor volume
This knob adjusts the volume of the input signal from the mic input jacks, guitar input jack, line input
jacks, and digital input jacks that is output from the headphone jack or master output jacks.
If this knob is set to the
116
1. Master output jacks (phone type)
These are analog audio output jacks. They output the same
sound as the master output jacks on the rear panel (RCA
2
phono type). Use the set of jacks that is appropriate for the
device you are connecting or the cables you are using.
2. Headphones jack
You can connect a set of headphones to this jack. The
headphones jack will output the same sound as the master
output jacks, the coaxial digital output jack, and the optical
3
digital output jacks. Even if headphones are connected,
4
sound will still be output from the master output jacks.
3. Input peak indicator
This lets you check whether distortion is occurring in the
sound that is input from the mic input jacks, guitar input
5
jack, or line input jacks. Adjust the input sensitivity knobs
for each input so that the peak indicator does not light.
6
1. Input monitor switch
This switches whether the input signal from the mic input jacks, guitar input
jack, line input jacks, and digital input jack will be output from the
headphone jack, master output jacks, and digital output jacks.
If this switch is on, the input signal will be output. If this switch is off, the
input signal will not be output. Turn this off (dark) if the audio data is being
position, the volume will be the same as the signal being recorded.
Publicité
Chapitres
