Recording A Guitar Or Bass - Edirol COSM Audio Capture UA-700 Mode D'emploi

Application guide

Recording a guitar or bass

With these connections and settings, only the guitar sound will be recorded on your computer
when you record into your sequencer application by playing your guitar along with the audio data
from your computer.
fig.guitar
The sound of the device connected to the Guitar input jack will be recorded on both the L channel
and R channel on your computer. It will also be output directly from the digital output jack.
Use the Input sensitivity knob to adjust the input level. For the best-quality recording, use the
input sensitivity knob to adjust the level until it is as high as you can get it without causing the
input peak indicator to light.
Turn on the Input monitor switch, and use the Input monitor knob to adjust the monitor volume
of your guitar or bass. This will not affect the recording level.
Do not connect anything to the input jacks that you are not using.
* Guitar effects cannot be applied if you are using 96 kHz PLAY/REC. In this case, only COMPRESSOR
& DE-ESSER and NOISE SUPPRESSOR & EQ can be applied.
130
Guitar / Bass
Adjust the
input level
Adjust the equalizer and
chorus/reverb
Signal flow
Turn this ON if you want to
monitor the input directly
Adjust the
effects