Application Guide; Basic Use - Edirol COSM Audio Capture UA-700 Mode D'emploi

Application guide

This chapter explains various ways in which you can connect and use the UA-700.
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn off the power on all devices before making any connections.

Basic use

You can connect headphones and/or monitor speakers as shown in the diagram, and monitor the
playback of your application, or the sound of instruments or audio devices connected to the
UA-700.
fig.basic
Computer
Using the sample rate select switch
• You must set the UA-700's sample rate select switch to match the sampling frequency used by
your application.
• If the sample rate select switch is set to 96 kHz REC, you will not hear the sound that is played
back by your application.
• If the sample rate select switch is set to 96 kHz PLAY, the sound of instruments or audio
devices connected to the UA-700 cannot be recorded by your application.
Mixer
USB cable
USB
connector
Audio amp
INPUT
Audio cable
LINE IN
Headphones
Signal flow
129