Publicité
Getting Connected and Installing Drivers (Macintosh)
4
From the CD-ROM, drag the Driver E–OMS Setting
folder into the Opcode–OMS folder on the hard disk
of your Macintosh to copy it there.
5
In the Opcode-OMS Application folder where you
installed OMS, double-click OMS Setup to start it up.
fig.03-omsusb1a.e
6
If a dialog box like the one shown
here appears, click [Turn It Off]. A
confirmation dialog box will then
appear, so click [OK].
fig.03-omsusb2.e
7
The Create a New Studio Setup
dialog box will appear.
Click [Cancel]. If you accidentally
clicked OK, click [Cancel] in the
next screen.
8
Choose "Open" from the File menu.
From the OMS Setting folder that you copied in step 4, select the UA-700
USB file, and click [Open].
fig.50
A screen like the one shown here
will appear.
42
This unit is equipped
with a protection circuit.
A brief interval (a few
seconds) after power up is
required before the unit
will operate normally.
We recommend that you
turn off AppleTalk, by
selecting Chooser from the
Apple menu.
Publicité
Chapitres
