Publicité
fig.3-2_40
5
If a message like the following is
displayed, click [Continue].
The other currently running
applications will exit, and
installation will continue.
6
A dialog box will indicate Installation completed. Click [Restart] to restart
your Macintosh.
FreeMIDI settings
To check the FreeMIDI settings, you will first need to connect a MIDI sound
module to the UA-700's MIDI OUT connector.
For details on connecting a MIDI sound module, refer to the owner's manual
for your MIDI sound module.
1
Use the USB cable to connect the UA-700 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
UA-700.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the UA-700 to your computer.
fig.advance-on
2
Set the UA-700's ADVANCE (mode select)
switch to the ON position.
3
Set the UA-700's power switch to the ON position.
4
From the CD-ROM, copy the Driver E - FreeMIDI Driver - Settings folder
onto the hard disk of your Macintosh.
5
Open the FreeMIDI Applications folder from the location into which you
installed FreeMIDI, and double-click the FreeMIDI Setup icon to start it up.
6
When "OMS is installed on this computer..." appears, click [FreeMIDI].
7
The first time the software is started up, a dialog box saying "Welcome to
FreeMIDI!" will appear.
Click [Continue].
Getting Connected and Installing Drivers (Macintosh)
Advance mode is
ON
Once the connections
have been completed,
turn on power to your
various devices in the
order specified. By
turning on devices in the
wrong order, you risk
causing malfunction and/
or damage to speakers
and other devices.
This unit is equipped with
a protection circuit. A
brief interval (a few
seconds) after power up is
required before the unit
will operate normally.
45
Publicité
Chapitres
