Publicité
Adjusting the volume of the effects
In some cases, the sound may become distorted during recording or playback when delay, reverb,
or other effect sound is added. If this occurs, use the following procedure to adjust the level
appropriately.
NProcedureN
1. Press and hold the Input Monitor switch for at least three seconds.
The Input Monitor switch and Guitar Effects switch will blink, and the UA-700 will enter a
mode that lets you adjust the Effect output level.
fig.02-4a
2. While listening to the sound, turn Effect control knob 1
(p. 121) until the sound is no longer distorted.
During recording, adjust this so that the Input level
indicator of your sequencer software does not reach the
maximum.
fig.02-4
If effect control knob 1 is set to the
volume will be at unity gain.
[Bypassed ... input:output are in a 1:1 ratio (0 dB)]
*
If you leave the Input Monitor knob and the Master Volume knob at the
recorded volume will be the same as the output volume. This is convenient when adjusting the effect
volume.
3. When you press the Input Monitor switch, it will stop blinking, and you will exit the Effect
output level adjustment mode.
*
The setting you adjusted will return to the factory setting when the power is turned off.
(0 dB = input:output ratio of 1:1)
*
The setting you adjusted can be stored in a patch.
Block diagram
fig.block2
position, the
SYSTEM
EFFECT
INPUT MONITOR
Effect output level
adjustment volume
2
1
3
position (0 dB), the
OUTPUT
Advanced applications
141
Publicité
Chapitres
