Publicité
Application guide
2. Adjust the driver buffer size.
The following setting will produce the shortest latency.
Windows:
Set "Audio Buffer Size" to the far left (Min).
Macintosh:
Set "Buffer Size" to the far left (Min).
3. Click [OK] to close the driver settings dialog box.
4. Restart the application that is using the UA-700.
If you are using an application that has a function for testing audio devices, get it to perform
its tests.
5. Play back audio data on your application.
If interruptions occur in the sound, repeat this procedure, and gradually increase the buffer
size specified in step 2 until interruptions no longer occur.
*
Depending on the application you are using, there may be a buffer size or latency adjustment function
among the audio settings of the application as well. For details, refer to the operation manual for your
application.
Using ASIO Direct Monitor
If you are using the UA-700 in Advanced mode from an ASIO 2.0 compatible application, the
UA-700's Input Monitor select switch can be controlled from your ASIO 2.0 compatible
application.
1. As described in Opening the special driver settings dialog box (p. 137), open the "Driver
Settings" dialog box.
2. Make the following settings.
Check the "Use ASIO Direct Monitor" check box.
3. Click [OK] to close the driver settings dialog box.
*
Depending on your application, there may also be an ASIO Direct Monitor setting among the audio
settings of your application. For details, refer to the operation manual for your application.
*
When using ASIO Direct Monitor, monitoring may switch on/off at unexpected times, depending on the
application settings and on the recording procedure. If this occurs, uncheck the check box in step 2 to
disable ASIO Direct Monitor.
136
Publicité
Chapitres
