Publicité
Getting Connected and Installing Drivers (Macintosh)
Switching between Advanced mode and Standard driver mode
If you first install both the special driver and the standard driver, you will be able to switch between
Advance and Standard driver modes by operating the UA-700's ADVANCE (mode select) switch.
* In order for the setting of the ADVANCE (mode select) switch to take effect, you must exit all sequencer
software and other applications that use the UA-700, switch off the UA-700, then turn it back on again.
Installing the special driver
You must install the MIDI driver even if you will be using only audio on the
UA-700. Be sure to install the MIDI driver.
Use either OMS or FreeMIDI as the MIDI driver.
If you are using OMS ..................................................... (p. 40)
If you are using FreeMIDI ............................................. (p. 44)
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate for
the sequencer software you are using.
* If the power of the UA-700 is turned on, a message like the following will appear when
the Macintosh is started up. Perform the steps described below as appropriate for the
message that is displayed.
If the screen indicates:
"Driver required for USB device 'unknown device' is not available. Search for driver on
the Internet?"
If the screen indicates:
"Software required for using device 'unknown device' cannot be found. Please refer to
the manual included with the device, and install the necessary software"
I Installing the UA-700 driver (OMS)
Use the following procedure to install the UA-700 driver.
The included UA-700 OMS driver is an add-on module for using the UA-700
with OMS. In order for you to use it, OMS must already be installed on the
hard disk from which you started up.
If you would like to learn more about OMS, refer to OMS_2.3_Mac.pdf in the
OMS Driver folder within the Driver E folder of the CD-ROM. You will need
the Adobe Acrobat Reader in order to view OMS_2.3_Mac.pdf.
* Disconnect the UA-700 from the Macintosh before you perform the installation.
40
➝ click [Cancel].
➝ click [OK].
OMS can be found in the
OMS Driver folder within
the Driver E folder of the
CD-ROM.
Publicité
Chapitres
