Battery Status Icon; Error Codes And Error Messages - Mettler Toledo IND231 Mode D'emploi

Follow local laws and regulations regarding the disposal of the NiMH battery pack.
3.3.3.

Battery Status Icon

The IND231/IND236 terminal provides a battery status icon in the lower right corner of the display
to indicate the amount of power remaining in the battery. Table 3-3 shows the full power and lower
power icons.
When the remaining battery power reaches the "extremely low" threshold, the battery graphic on the
display will blink, indicating that the battery is getting low. It will continue to blink until the batteries
are replaced (alkaline battery version) or the terminal is connected to AC power (NiMH version). If
the battery condition is not addressed and the voltage continues to drop, the terminal will turn itself
off.
3.3.4.

Error Codes and Error Messages

The IND231/IND236 terminal uses a combination of error codes and error messages to indicate
error conditions that occur in the terminal. Table 3-4 provides a list of error codes that may appear.
30100541 | 00 | 08/2013
Graphic
THE BATTERY USED IN THIS DEVICE MAY PRESENT A RISK OF FIRE OR CHEMICAL BURN IF
MISTREATED. DO NOT CRUSH, DISASSEMBLE, HEAT ABOVE 60°C OR INCINERATE. REPLACE
BATTERY WITH 30044650 ONLY. USE OF ANOTHER BATTERY MAY PRESENT A RISK OF BURN,
FIRE OR EXPLOSION.
For further information about battery operation, please refer to the enclosed Documentation CD-
ROM.
Message
Over load, more than 9d above
scale capacity
Under Zero by more than 5d
Outside the zero range
Table 3-3: Battery Status Icon
Battery Condition
Full power
Less than 10% charge remaining
CAUTION
Table 3-4: Error Codes
Possible reasons
Reduce the load
Zero the scale
Remove the load
Confirm that all initial weight is
on the scale platform
METTLER TOLEDO IND231/IND236 Quick Guide
Solution
3-3