Ribimex Ribiland PRTRE300R Manuel D'instructions Et D'utilisation page 30

- Wear protective equipment and always wear protective goggles while operating the tool.
Wearing protective equipment such as a dust mask, non-slip footwear, protective gloves, a helmet
and hearing protection (depending on the type and application of the electrical device concerned)
reduces the risk of injury.
- When performing work that generates dust, wear a dust protective mask to prevent dust irritation.
- Each time before you use the tool, check the integrity of the product's power cord and your own
extension cord for signs of damage and ageing. Do not use the tool if the cord is damaged or worn. -
The product should only be operated when its accessories are in perfect working order.
Any damaged or defective components should be repaired immediately by a qualified technician.
Never attempt to use an incomplete, not fully assembled or modified tool.
- Under no circumstances should the tool be operated while safety devices or protective guards or
shields are damaged or if safety equipment such as protective devices is not installed.
- Only use a weather proof extension cable fitted with coupler to IEC 60320-2-3.
Only extension cords that are rated for outdoor use should be used outdoors.
Any extension cord used should have a minimum cross section of 1.5mm
should have an earth contact and water-spray shielding.
- Browse the working area to:
-- remove all objects and foreign materials that may be thrown by the tool,
-- identify hard objects or risk areas to avoid damaging the tool.
3.3.2- Before starting the product
- Local or national regulations may limit the use of the product during specific hours of the day and
only by certain users; seek information with your local authority.
- Never operate this product when you are fatigued, ill, or upset, or under the influence of medication
that may make you drowsy, or if you are under the influence of alcohol or drugs
- Only operate the product after completely assembling it.
Do NOT operate product if protective device is not fully and properly assembled!
- Before each use, check the tool for any signs of damage.
- Prior to each use, check the power cord for signs of damage. Under no circumstances should the
power cord be used if it shows any signs of damage.
- Only use splash-proof extension cord approved for outdoor use and marked accordingly.
Make a loop in the extension cord and hang into the cable holder.
- Ensure that the tool is only connected to conventional sockets with a 230V alternating current
supply.
- The tool can be plugged into any 230V AC outlet with 10 amps of fuse protection. The electrical
outlet is to be protected by an earth leakage circuit breaker (ELCB) with a max triggering current
of 30mA (i.e. the appliance should be supplied via a Residual Current Device (RCD) with a tripping
current of not more than 30mA).
3.3.3- During use
- Always direct the cable to the rear away from the tool and working path. Make sure the power cord
is kept behind and away from the device while you work.
- If the power cord or extension cord becomes damaged during use, disconnect the supply cord from
the mains immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE
SUPPLY CORD FROM ITS POWER SOURCE.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
- Do not carry the tool by the cable. Never use the power cord as a handle to lift or carry the tool.
- Always disconnect the product from the mains supply in the following circumstances:
-- whenever you leave the tool; when the tool is not in use, is being carried/transported, or is left
unattended.
-- before clearing a blockage; while examining, cleaning or unclogging the cutting devices.
2
. All plug-in connections