Programming Of The Channels - Bodet MICROQUARTZ 6 Instructions De Mise En Service

PROGRAMMING OF THE CHANNELS

The 6 channels can be programmed in TIMER MODE (bells) or in ON/OFF mode.
To program a channel :
- Set the corresponding channel switch to Program mode.
- Key-in the day, hour, minute, signal duration (or ON/OFF) by means of the day,
hour, minute and sec keys.
- The display blinks : data are on stand-by.
- Enter : the display becomes still (data are recorded).
The mode selection is done as follows :
If channels (4,5,6) have been preset for SR3, D1 D2, Telesect or sync-wired slave clock
systems, they are not accessible for programming.
Example : Programming of channel (C4) for bells
- Set the keypad switch to ON.
- Set the channel C4 (13) switch to Program :
If the channel already contains a programme, the first program step
is displayed.
- Set the signal day, hour, min and duration (in any order).
EG. Monday 08 H 45 duration 5 sec.
- Enter : The display becomes still, the data are recorded.
For other steps proceed as above.
After programming is terminated :
· Set the channel switch C4 (13) to normal.
· Set the keypad switch to OFF.
Reading the programme :
- Set the keypad switch to ON.
20
· OFF (open circuit)
· ON (closed circuit)
· TIMER (2 to 59 sec.) EG. 6 sec