Set Up Of Clock System - Bodet MICROQUARTZ 6 Instructions De Mise En Service

- Open the antenna box.
- The antenna must be perpendicular to the transmitter direction :
ALLOUIS (F) for FI antenna, MAINFLINGEN (Germany) for DCF and cable joint towards the
ground.
- The position is correct if :
· The LED in antenna box and on Microquartz 6 blinks once per second
· The sound in the earphone is clear and disappears once per second (AD 10
antenna).
- Fix the antenna on its bracket
- Close the box taking care of the waterproof joint.
Note : The clock synchronizes itself on time after 5 to 15 minutes. However in case of
difficult environment it may take as much as 24 h to endure synchronization.

SET UP OF CLOCK SYSTEM

The Microquartz 6 is designed to operate various types of time systems using the slave
clock ling output and 1,2 or 3 channels of the programmer. The unit is delivered from the
factory adjusted for 1 min. 24 V reverse polarity.
In order to obtain other types of impulses operate as indicated using the 3 keys RESET,
SECOND and ENTER :
- remove the cover
- set the keyboard switch to ON
- press 4 times on RESET key. The display shows :
PO = Selection of the clock system type
Code on
display
Minute 24 V // polarized
PO 00
1/2 minute 24 V or serial
PO 01
SR2 (hourly supervision 59' 2 wires)
PO 02
SR3 (hourly supervision 59' 2 wires)
PO 03
16
Type of impulses Output terminal
PC
AB
C
A
6
B
220
N
0
D1
5
6
D2
18
18
18
18
15
19
15