Setting The Time - Bodet MICROQUARTZ 6 Instructions De Mise En Service

P3 Selection of radio synchro mode (P2-00 must be entered)
P3...00 : official time by DCF 77 or FRANCE INTER
P3... 1 : official time by DCF 77 or FRANCE INTER plus 1 hour
P3...— : Synchro radio without summer / winter time changeover
P3...-1 : official time by DCF 77 ofr FRANCE INTER less 1 hour
- Enter : The display shows the 1st programme step entered
The programming is completed.
Programme control
- Press successively on ENTER to display the programme steps.
Programme exit
- Press the RESET key. The display shows :
Note : A further press on the RESET key will open the TEST programme (see P.20). To
re-enter the set up programme, start the clock, then stop it (Start/Stop key) and then press
the RESET key 4 times.

SETTING THE TIME

Clock system start up
If the master clock has been set up to control 2 separate slave clock circuits, setting the time
of each circuit is done independently to allow for the reset of one circuit only.
- Clock circuit : 24 V minute, 1/2 minute, SR2/SR3
. Set all slave clocks on the same time.
. Remove the cover of the MICROQUARTZ.
. Set the keyboard switch to ON.
. Stop the clock by pressing the Stop/Start key : the pilot Led lights up.
. Set the Microquartz to the time shown on the slave clocks by means of the + 1 h, - 1 h,
minute keys.
. Start the clock by pressing the Stop/Start key : the pilot LED switches OFF.
. Immediately press the synchro key : the slave clocks are now synchronized.
. Set the keyboard switch to OFF.
- Clock circuit : D1 D2-3 wires, Telesect 4-wires
18