Publicité
2.
Fit spacer (4) into pawl (27). Then continue to assemble using bolt (3),
support brackets (26) and nut (11) as shown.
ImpORTANT!
Do not tighten
hardware
completely.
3.
Flip pawl (27) back to allow easier access to assembly area.
Attach lower elevator tubes (28) to backboard brackets using
spacers (7, 10 and 12), bolt (6), ratchets (29), and nut (8) as
shown.
ImpORTANT!
Do not tighten
hardware
completely.
27
6
7
10
28
9
3
26
7
8
10
29
28
12
29
11
26
27
4
ImpORTANT!
Test fit bolts into
holes of backboard
brackets and
carefully rock them
in a circular motion
to ream out paint
from holes if
necessary.
ImpORTANT!
flip pawl (27) back to
allow easier access
to assembly area.
Publicité
