Publicité
3.
Hold angled brackets (23 and 24) on roof and keep u-channel (21) upright. Measure from top of playing
surface to upper elevator hole in u-channel. Distance should be 106-3/4"" (2.71 m).
A.
Mark angled bracket locations on roof. Angled brackets (23 and 24) should
be parallel to each other before the bend and be 3-1/2" (8.9 cm) apart.
WARNING!
TWO cApAblE ADulTs
REQuIRED fOR ThIs
pROcEDuRE. fAIluRE TO
fOllOW ThIs WARNING
cOulD REsulT IN
sERIOus INjuRy AND/OR
pROpERTy DAmAGE.
NOTE:
To achieve 106-3/4" (2.7 m) you may
have to make some adjustments.
such as turning the tube over on the
opposite end, and/or moving angled
brackets backward or adding height
to the entire assembly with wood
between angled brackets and roof.
4.
Drill holes in roof. Position angled brackets and secure
to roof.
A.
WARNING!
All mounting points should
be sealed to prevent leaks
and water damage"
23
3-1/2" (8.9 cm)
minimum distance should
be 106-3/4" (2.71 m) from
top elevator hole to playing
surface. homeowner must
assume all responsiblilty for
any personal or property
damage if backboard height
is lower than recommended.
22
21
20
21
24
WARNING!
Keep u-channel (21) upright and
5.
position struts (22) on desired
location on roof approx. 26"-30" (66-
A.
76 cm) apart. Level tube in all
directions. Mark and drill holes.
Secure struts in place.
21
21
106-3/4"
(2.71 m)
22
Publicité
