Renishaw RP1 Mode D'emploi page 13

RP1/RP1 DD INSTALLATION dimensions mm (in)
NOTE It is essential that design of the probe installation prevents coolant from contacting the rear of
the probe.
RP1 probe
M4 x 0,7
➤ ➤ ➤ ➤ ➤
➛ ➛ ➛ ➛ ➛
FACE B
See Note 2
RP1 DD probe
M4 x 0,7
➤ ➤ ➤ ➤ ➤
NOTES
1. Side lead exit may be in any position
on diameter marked thus XXXXXXXXX.
2. Ensure face B of module body is
flush within 0.2 mm (0.008 in) of face C
of housing on installation.
3. To secure probe during installation, lock
M5 flat end grubscrews (2 off, supplied by
user) into location c/sinks in probe body.
Side or rear lead
exit customer
configurable.
Wire length
300 mm (2 off)
Location
c/ sink
Side or rear lead
exit customer
configurable.
Wire length
300 mm (2 off)
D D D D D
16,6 (0.65)
20°
4
(0.16)
Ø28,90
Ø28,80
(1.138
1.134)
0,8
A
0,5 x 45°
(0.33
FACE C
0.32)
See Note 2
5,6
5,4
(0.22
0.21)
D D D D D
2 holes M5 x 0,8
to depth shown.
23,5 (0.92)
See Note 3
minimum
minimum
minimum
SECTION D - D
8,5
8,3
1-3
Ø6
(0.24)
lead exit