Reverse The Door Swing - Norcold DC0788B Manuel D'installation Et Guide Du Propriétaire

2. Lift the door off the bottom hinge.
3. Remove the panel retainer by prying the retainer
out of the slot (See Art01985).
4. Gently pull the door panel out of the door.
5. Push a new door panel into the door slot.
6. Put the panel retainer in the original location and
press the retainer back into the slot.
7. Put the door in the original location and tighten
the two (2) bolts.

Reverse the door swing:

1. Remove the door from the refrigerator by
removing the two (2) bolts that attach the door
hinge to the bottom of the refrigerator (See
Art01986).
2. Remove the two (2) bolts that attach the upper
hinge.
3. Remove the bolt that attaches the door latch plate to
the top of the refrigerator (See Art01987).
4. Remove the upper hinge and the door latch plate
from the refrigerator.
5. Attach the upper hinge and the door latch plate to the
opposite sides of the refrigerator.
6. Move the latch to the opposite side of the door (See
Art01988):
- Remove the screw that attaches the latch handle
and the latch pin.
- Remove the latch handle pin and the coil spring
from the door.
- Move the set screw to opposite side of the latch
pin.
- Assemble the coil spring and the latch pin into the
opposite side of the door.
Door hinge
Door hinge
Door latch plate
Art01987
9
Bolts
Bolts
Art01986
Bolts
Screw
Latch handle
Latch pin
Set screw
Coil spring
Door
Art01988