Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
The refrigerator must be located and secured on a solid surface in the vehicle or
watercraft.
Before installing the refrigerator into the opening, make sure the DC supply is
properly connected.
Measure the opening to determine if you have proper clearance for installation.
Additional insulation space around the refrigerator is not necessary.
Be sure the refrigerator is not in direct sunlight or near a gas stove, a heater, or other
heat-generating appliances. Avoid installing your refrigerator close to warm water lines
or warm air ducts.
Your refrigerator was thoroughly cleaned before shipment from the factory. It is
advisable, however, to clean the interior once more before using. Wipe the interior with
a cloth and warm water. Then wipe with a dry cloth.
Ventilation
Sufficient ventilation (airflow)
over the rear mounted
condenser of the refrigerator is
necessary for the refrigerator
to operate correctly. Use any
F
of the following combinations
C
of vent openings: A-D, A-I, A-J,
E
B-C, B-F, B-H, C-D, C-I, C-J,
D-F, D-H, F-I, F-J, G-I, G-J, H-I,
H-J (See Art01129 - for 0788
A
models only).
H
For the minimum required
ventilation, each individual vent
G
opening should be no less than
D
50 square inches. However,
the vent openings should
J
be larger, to allow as much
ventilation as possible. The
I
more air that circulates over
B
the refrigerator condenser, the
more efficiently the refrigerator
will operate.
Art01129
7
Publicité
Table des Matières
