Install Decorative Door Panels; Reverse The Door Swing- (Optional) - Norcold 10 Serie Manuel D'installation

- Make sure that the bend of the baffle is the full width of the inside of the enclosure.
- Make sure that the bend of the baffle is flush with the bottom edge of the upper intake vent door frame.
- Make sure that the top edge of the baffle is 1/4 inch [213] below the bottom of the condenser and that there is 1/4 inch or
less clearance [15] between the rear of the condenser and the baffle.
- If the depth of the enclosure is more than 26 inches [27], install a wood or an aluminum or galvanized steel sheet solid box
baffle [21] between the lower intake vent and the upper exhaust vent (See Art 02699).
- Make sure that the solid box baffle is the full width of the inside of the enclosure.
- Make sure that the bottom of the solid box baffle is 18 inches to 18 1/2 inches above the bottom of the enclosure [17] (4
1/4 inches to 4 3/4 inches above the top of the lower intake vent opening REF) [18] .
- Make sure that the back of the solid box baffle is perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box baffle is even with the bottom edge of the upper exhaust vent [24].
- Make sure that the vertical top edge of the baffle is between 1/4 inch [213] below the condenser [3] and 1 1/2 inches
above the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffle.

Install Decorative Door Panels

The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
NOTICE
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 15 17/32 inches
high.
- Make a lower door panel that is:
- 21 19/32 inches wide and 39 5/8 inches high
- Pull the panel retainer [37] off each door (See Art 02624).
- Push the decorative door panel [38] into the slots of the door [39].
- Push each panel retainer into the slot on the edge of the door.

Reverse the Door Swing- (optional)

This refrigerator has cabinet hinges that allow you to change the direction the door opens by moving the hinges to the opposite side.
is recommended this be done before installing the refrigerator into the enclosure.
1. Remove the doors (See Art 02683):
- Remove the storage bins from the doors.
NOTICE
Do not mix the upper and lower hinge pins because they are different.
- Remove and save the upper hinge pin [63] from each hinge.
- Pull the door latch and remove each door from the refrigerator.
- Remove and save the lower hinge pin [64] from each hinge.
Installation Manual 10
38
37
Art 02624
39
It
63
66
64
67
ART 02683