Reverse the Door Swing (optional)
This refrigerator has cabinet hinges that allow you to change the
direction the door opens by moving the hinges on a diagonal to the
opposite side.
1. Remove the control cover:
- Carefully pull the snap-on control façade [271] off of the control
cover [270] (See Ar02386).
- Set the control façade aside.
- Remove the two outermost screws [41] from the control cover.
- Pull the control cover away from the refrigerator.
- Set the control cover aside.
2. Remove the doors:
- Remove the storage bins from the doors.
Do not mix the upper and lower hinge pins because
NOTICE
they are different.
- Using either a 7/16" wrench or a straight screwdriver, remove and save the
upper (hex-head) hinge pin [63] from each door (See Art02387).
- Open each door, tilt it slightly forward, and pull it up and off of the bottom
hinge bushing.
3. Change the position of the strike plates:
- Remove and save the two screws [41] that attach the strike plate [65A] for
the upper door to the refrigerator (See Art02388).
- turn the strike plate over and attach it in the location for the strike plate [65B]
of the lower door on the other side of the control area.
- Use the same procedure to change the position of the other strike plate.
Installation Manual 12
270
Art02386
Art02387
41
65A
41
271
Art02388
63
65B