Reverse The Door Swing (Optional) - Norcold NX61 Manuel D'installation

Reverse the Door Swing (optional)

This refrigerator has cabinet hinges that allow you to change the
direction the door opens by moving the hinges on a diagonal to the
opposite side.
1. Remove the control cover:
- If the unit is equipped with a plastic control facade [271];
- Carefully pull the snap-on control facade off of the control
cover[270] (See ART 02386) and set aside.
- If the unit is equipped with an adhesive control label [271];
- Carefully peel the adhesive control label off the control cover [270]
(See Art02386) and set aside.
- Remove the two outermost screws [41] from the control cover.
- Pull the control cover away from the refrigerator.
- Set the control cover aside.
2. Remove the doors:
- Remove the storage bins from the doors.
Do not mix the upper and lower hinge pins because they are
NOTICE
different.
- Using either a 7/16" wrench or a straight screwdriver, remove and save the
upper (hex-head) hinge pin [63] from each door (See Art02387).
- Open each door, tilt it slightly forward, and pull it up and off of the bottom hinge
bushing.
3. Change the position of the strike plates:
- Remove and save the two screws [41] that attach the strike plate [65A] for the
upper door to the refrigerator (See Art02388).
- turn the strike plate over and attach it in the location for the strike plate [65B]
of the lower door on the other side of the control
area.
- Use the same procedure to change the position of
the other strike plate.
Installation Manual 12
270
41
Art02386
Art02387
41
65A
271
Art02388
63
65B