BH LKT8 Manuel Du Propriétaire page 19

PROGRAM MODE
P1 - MANUAL RUN
After you have selected this mode, the program will order you to put in the following values:
Time: Preset Value 0 min, Range: 20~99(min). After you have selected the values press
ENTER or QUICK START to start immediately.
P2 9-HOLE WALK
When you select this mode, the program will require you to input the following values:
The speed and incline windows will display the top speed and top incline ranges under this
program. At this time, the speed window will blink and you can increase or decrease the
speed range. Press the UP/DOWN speed buttons to change the speed. When the top speed
shown in the window changes, the surplus preset program values will increase or decrease by
degrees. After selecting, press ENTER and the incline window will blink. You can increase
or decrease the incline range. Press the UP/DOWN incline buttons to change the incline.
When the top incline shown in the window changes, the surplus preset program values will
increase or decrease by degrees. After selecting, press ENTER or QUICK START and the
exercise will begin. When the distance reaches 3.5 KM, the motor will stop and the incline
goes back to 0, displaying "End".
P3 HILL CLIMB
When you select this mode, the program will require you to input the following values:
Time: Preset Value: 30min, Range: 20~99 (min), Step 1min. After you have selected the
right values, press ENTER to enter the setting of the next value.
The speed and incline windows will display the top speed and top incline ranges under this
program. At this time, the speed window will blink and you can increase or decrease the
speed range. Press the UP/DOWN speed buttons to change the speed. When the top speed
shown in the window changes, the surplus preset program values will increase or decrease by
degrees. After selecting, press ENTER and the incline window will blink. You can increase
or decrease the incline range. Press UP/DOWN incline buttons to change the incline. When
the top incline shown in the window changes, the surplus preset program values will increase
or decrease by degrees. After selecting, press ENTER or QUICK START and the exercise
will begin.
4. ENDURANCE RUN P4
When you select this mode, the program will require you to input the following values:
Time: Preset Value: 30min, Range: 20~99(min), Step 1min. After you have selected the right
values, press ENTER to enter the setting of the next value.
19