Power Trim And Tilt Switch On Remote Control Or Tiller Handle; Power Trim And Tilt Switch On Bottom Cowling - Yamaha F115 Manuel De L'utilisateur

Components
TIP:
 Check the tiller handle for smooth move-
ment when the lever is turned to the star-
board side "B".
 Do not apply lubricants such as grease to
the friction areas of the steering friction ad-
juster.
EMU26144
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
For instructions on using the power trim and
tilt switch, see pages 72 and 74.
35
EMU26156
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch "
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 74.
" (up) trims the
EWM01032
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
" (up) trims the outboard motor up,
WARNING
"