Viewing The Stored Values; Memory Full; Clearing All Values; How Not To Store A Reading - Microlife BP W2 Slim Mode D'emploi

Viewing the stored values

Select either user 1 or 2 with the user switch 7.
Press the M-button 5 briefly, when the device is switched off. The
display first shows «M» AN and then a value, e.g. «M 17». This
means that there are 17 values in the memory. The device then
switches to the last stored result.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored value
to another.

Memory full

Pay attention that the maximum memory capacity of 60 memo-
ries per user is not exceeded. When the 60 memory is full, the
oldest value is automatically overwritten with the 61st
value. Values should be evaluated by a doctor before the
memory capacity is reached – otherwise data will be lost.

Clearing all values

Make sure the correct user is activated.
If you are sure that you want to permanently remove all stored
values, hold down the M-button (the device must have been switched
off beforehand) until «CL» appears and then release the button. To
permanently clear the memory, press the M-button while «CL» is
flashing. Individual values cannot be cleared.
6

How not to store a reading

As soon as the reading is displayed press and hold the ON/OFF
button 1 until «M» AN is flashing. Confirm to delete the reading by
pressing the M-button 5.

7. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol AQ
will flash as soon as the device is switched on (partly filled battery
displayed). Although the device will continue to measure reliably, you
should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol AQ will flash as soon
as the device is switched on (flat battery displayed). You cannot take
any further measurements and must replace the batteries.
1. Open the battery compartment 3 by pulling off the cap.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
3. To set date and time, follow the procedure described in «Section 2.».

The memory retains all values although date and time must be
reset – the year number therefore flashes automatically after
the batteries are replaced.