Sleeping Mode - SOMFY Roll Up 28 Notice D'utilisation

EN
2. 4. 5. Erasing control points (transmitters) from memory
To delete all the programmed transmitters, press and
hold the motor head programming button until the driven
product briefly moves Up and Down twice. All
programmed control points (transmitters) are deleted.
2. 4. 6. Erasing the memory of the motor (factory default)
To reset the motor, press and hold the motor head
programming button until the driven product briefly
moves Up and Down 3 times.
All the settings are erased.

2. 4. 7. Sleeping mode

1
The driven product must be programmed.
Β
This feature temporarily prevents the drive product from responding to any previously programmed control
points (transmitter) commands.
1) Press and hold the motor head programming button
until the driven product briefly moves Up and Down.
2) Briefly press the motor head programming button,
the driven product briefly moves Up and Down
twice. "Sleeping mode" is activated.
3) To deactivate the "Sleeping mode", briefly press the
motor head programming button. The driven product
briefly moves Up and Down, the control point
(transmitter) commands are enabled.
8 Copyright © 2017 - 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved
Roll Up 28 WireFree RTS
1
2
3
2x
3x
2x