Stopping The Machine; Blade Adjustment - Enarco TIFON Serie Manuel D'instructions

STOPPING THE MACHINE

Electric motor:
Put direction switch on "0" position and get the plug out.
Do not leave the machine before getting the plug out.
Petrol engine:
Never use the choke to stop the engine. Leave the machine run at an idle speed for 2-3 minutes to
cool down
Move the Gas lever to minimum throttle.
Turn the button, which is on the gasoline engine, to the OFF position to stop the machine lastly.

BLADE ADJUSTMENT

The blade pitch control wheel is easy to reach for the operator. To adjust the pitch, just turn the
wheel clockwise or anticlockwise, depending on the desired pitch position. During finishing, setting
up/hardening may vary from area to area across the floor, so the pitch adjustment can be changed
to suit accordingly while the machine is in operation. When transporting the trowel on a truck, always
keep blades fully horizontal/flat on the floating disc.
MAINTENANCE TABLES
Power trowels with petrol engine:
CLEAN THE MACHİNE BYE PRESSURIZED WATER
CHECK THE BLADE PITCH ADJUSTMENT
CHECK THE BLADE PITCH BOLTS AND CHECK OTHER BOLTS OF
THE MACHINE, IF NECESSARY TIGHTEN THEM
CHECK ENGINE OIL LEVEL
CLEAN AIR FILTER
CHECK THE V-BELT TIGHTNESS
CHECK THE BLADES
CHANGE ENGINE OIL
PUT OIL TO THE GREASE FITTINGS
TROWELS WITH ELECTRIC OR PETROL ENGINE
DAILY WEEKLY
X
X
X X
X
X
X
X
X
X
en
9