MINN KOTA TERROVA Instructions D'installation page 9

7
ITEM(S) NEEDED
#2 x 6
a. Put a 1/4-20 x 2" (Item #1) screw in each of the
drilled locations. The screw should pass through
the Base Extrusion and the boat deck. If the rubber
washers (Item #4) are used, they should sit between
the Base Extrusion and boat deck. Make sure to
secure the motor with screws on each side of the
Base Extrusion.
b. Place a Flat Washer (Item #2) and then a Nylock
Nut (Item #3) at the end of each screw as shown
and secure. Make sure all hardware is secure.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
8
c. Replace the Right Sideplate.
d. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
8m
©2021 Johnson Outdoors Marine Electronics, Inc.
#1 x 6 #3 x 6
Right Sideplate Right Sideplate
INSTALLING THE TERROVA
#4 x 6
Screw Screw
Rubber Rubber
Washer Washer
Nylock Nut Nylock Nut
Flat Washer Flat Washer
8n
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
Boat Deck Boat Deck
minnkotamotors.com | 9