MINN KOTA TERROVA Instructions D'installation page 18

INSTALLING THE PROP
INSTALLING THE PROP
1
ITEM(S) NEEDED
#17 x 1
CAUTION
Disconnect the motor from the battery before beginning any
prop work.
a. Take the Drive Pin (Item #14) and slide it through
the Hole in the Armature Shaft. Position the Drive
Pin horizontal by grasping the Armature Shaft and
rotating it with the Drive Pin in place.
b. Align the Propeller (Item #17) so it is also horizontal
and parallel with the Drive Pin. Slide the Propeller
onto the Armature Shaft and Drive Pin until it is
seated against the lower unit.
c. Install the Prop Washer (Item #15) and the Prop
Nut (Item #16) onto the end of the Armature Shaft.
d. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Prop Nut with a 9/16"
Open End Wrench.
e. Tighten the Prop Nut 1/4 turn past snug to 25-35
in-lbs.
CAUTION
Do not over tighten as this can damage the prop.
18 | minnkotamotors.com
#15 x 1 #16 x 1 #14 x 1
1a
Drive Pin Drive Pin
Prop Washer Prop Washer
1b
1d
Prop Nut Prop Nut
Prop Washer Prop Washer
Propeller Propeller
Armature Shaft Armature Shaft
Propeller Propeller
Prop Nut Prop Nut
Propeller Propeller
Drive Pin Drive Pin
©2021 Johnson Outdoors Marine Electronics, Inc.