MINN KOTA TERROVA Instructions D'installation page 7

2
a. Remove the Right Sideplate.
b. Swing the Left Sideplate out and away from the
Base Extrusion.
2c
3
c. Make sure that the Power Cables from the battery
are disconnected, or that the breaker,
if equipped, is "off."
WARNING
Make sure the motor is mounted on a level surface and is
not connected to a power source.
4
d. Place the mount as close to the centerline or keel of
the boat as possible. The motor can be installed on
either the Port or Starboard side of the boat based
on personal preference. Check placement with the
motor in the stowed and deployed positions.
Review the mounting considerations at the
beginning of the installation.
©2021 Johnson Outdoors Marine Electronics, Inc.
Right Sideplate Right Sideplate
INSTALLING THE TERROVA
2d
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
Power Cables Power Cables
Keel Keel Deck of Boat Deck of Boat
minnkotamotors.com | 7