MINN KOTA TERROVA Instructions D'installation page 17

1
a. Place the motor in the deployed position.
b. The i-Pilot Link connector from the Control Head is
an 8-pin connector. Locate and identify the correct
connection for i-Pilot Link, at the base of the
Control Head.
NOTICE:
i-Pilot Link will be paired with either
Built-in MEGA Down Imaging or Universal Sonar
on Ultrex, Ulterra or Terrova. i-Pilot Link is not a
feature offered on Fortrex motors.
NOTICE:
Paired with a Universal Sonar connector
for illustration purposes. A Built-in MEGA Down
Imaging connector may be present instead.
NOTICE:
Critical cable routing for 60" and 72" motors with i-Pilot Link and Built-in MEGA Down Imaging. Accessory
Cables must exit the Coil Cord leaving three or more open coils between where the cables exit and the motor base; as
assembled by the factory. Routing the cables in any other manner will not allow the motor to stow properly.
2
ITEM(S) NEEDED
c. If necessary, to reach the installed fish finder, take
the i-Pilot Link Ethernet Cable (Item #12) and attach
it to the i-Pilot Link cable exiting the Control Head.
NOTICE:
If any cables need to be routed, please
follow the guidelines in the Routing Connection
Cables section of these installation instructions.
d. Install the i-Pilot Link Ethernet Cable directly into
the Humminbird fish finder, or refer to your fish
finder installation manual for complete installation
instructions. If an Adapter Cable is needed (Ethernet
Adapter Cable AS EC QDE for Helix fish finders),
install it on the end of the i-Pilot Link Ethernet
Cable and refer to your fish finder installation
manual for complete installation instructions.
©2021 Johnson Outdoors Marine Electronics, Inc.
FEATURE OVERVIEW AND CONNECTING THE CABLES
#12 x 1
i-Pilot i-Pilot
Link Link
Built-in MEGA Built-in MEGA
Down Imaging or Down Imaging or
Universal Sonar Universal Sonar
Mount Mount
Eight-Pin Eight-Pin
Connector Connector
Locking Collar Locking Collar
i-Pilot Link Ethernet i-Pilot Link Ethernet
Cable from Control Head Cable from Control Head
NOTICE:
The connectors are keyed to prevent
reversed installation.
Control Head Control Head
Coil Coil
Cord Cord
i-Pilot Link Ethernet i-Pilot Link Ethernet
Extension Cable OR Extension Cable OR
Ethernet Extension Cable Ethernet Extension Cable
minnkotamotors.com | 17