ROUTING CONNECTION CABLES
1
a.
Place the motor in the deployed position.
b.
Locate the Built-in MEGA Down Imaging, i-Pilot
Link and/or Universal Sonar cable(s), at the base of
the Control Head.
CAUTION
Not following the recommended wire routing for the Built-in
MEGA Down Imaging, i-Pilot Link and/or Universal Sonar
cable(s), if equipped, may cause damage to the product and
void your product warranty. Route cables away from pinch
points or other areas that may cause them to bend in sharp
angles. Routing the cables in any way other than directed may
cause damage to the cables by being pinched or severed.
NOTICE:
Universal Sonar connector shown for
illustration purposes.
2
c.
The cable(s) should be fed all the way through the
Coil Cord. It/they should exit the Coil Cord at the
bottom of the Coil Cord, where it connects to the
Mount.
Two Connections
i-Pilot
i-Pilot
Link
Link
12 | minnkotamotors.com
Control Head
Control Head
Built-in MEGA
Built-in MEGA
Down Imaging or
Down Imaging or
Universal Sonar
Universal Sonar
Coil
Coil
Cord
Cord
Mount
Mount
One Connection
Built-in MEGA
Built-in MEGA
Down Imaging or
Down Imaging or
Universal Sonar
Universal Sonar
Coil Cord
Coil Cord
Two Connections
i-Pilot
i-Pilot
Link
Link
Built-in MEGA
Built-in MEGA
Down Imaging or
Down Imaging or
Universal Sonar
Universal Sonar
Universal Sonar
Universal Sonar
Connector
Connector
One Connection
Built-in MEGA
Built-in MEGA
Down Imaging or
Down Imaging or
Universal Sonar
Universal Sonar
Coil Cord
Coil Cord
NOTICE:
After the cable(s) exit(s) the Coil Cord, it/they
should be routed through an established routing system on
the boat, in an area with minimal interference. Power cables
or other elements that may produce interference for the
sonar signals. Inspect the selected route carefully to ensure
that there are no sharp edges, obstacles, or obstructions
that may damage the cables.
Control Head
Control Head
Control Head
Control Head
Coil Cord
Coil Cord
Control
Control
Head
Head
Mount
Mount
©2021 Johnson Outdoors Marine Electronics, Inc.