Adjusting The Tilt/Extend Tiller - MINN KOTA 1355954 Manuel Du Propriétaire

Adjusting the Tilt/Extend Tiller

Your trolling motor features 7 usable handle tilt positions: 45°, 30°, and 15° up and down from the 0° (horizontal) position. To use the
down positions, you must first press the release button located on the left underside of the pivot handle.
Your trolling motor handle also features a unique stow position, that is useful for limiting the amount of space required for storage or
travel.
1
a. Place the Tiller handle in the Off/Stow position,
then press the Release Button located on the left
underside of the pivot handle. Push the handle down
until you feel the handle "lock in" to the stowed
position. This will be almost parallel to the motor
Shaft.
b. To extend the handle, pull the handle towards you to
the desired position. The handle will extend a full 6
inches. To retract, push the handle in until it
meets the face of the motor Control Head.
WARNING
The Pontoon Hand Control is not intended to be a primary
propulsion motor. Heavy use of the motor can cause
elevated motor temperatures, which can be increased by
an excessively hot operating environment. Use care when
handling the Control Head to avoid burns or injuries from
excessive heat. In the event that the motor or speed control
would break, always be prepared to take manual control of
the boat.
Before attempting to put the handle in the stowed position, the speed selector must be in the OFF/STOW position. Failure to do so
will damage the internal mechanism.
©2019 Johnson Outdoors Marine Electronics, Inc.
ADJUSTING THE DEPTH OF THE MOTOR
Handle Controls:
Off/On, Steering, and
Forward/Reverse
The position of the Tilt/Extend Tiller may create a pinch point
between it and the Control Head. Grasp the motor away from
the area that may come in contact with another area of the
motor to prevent injury.
CAUTION
Shaft
WARNING
Release Button
Control Head
minnkotamotors.com | 21