MINN KOTA 1355954 Manuel Du Propriétaire page 9

2
b. Once in position, mark a minimum of four of the six
Mounting Holes, two on each side. Drill through the
marked holes using a 9/32 drill bit.
NOTICE:
The four front Mounting Holes use the same
bolt pattern as used on Minn Kota Quick Release
Brackets for the MKA-21, RTA-17, MKA-16-03 and
MKA-32. The Mounting Bracket for the Pontoon
Hand Cotrol may be attached to any of these for your
mounting convenience.
3
c. Remove the Motor Assembly from the Mounting
Bracket by loosening the Steering Tension Knob and
opening the Latch and Door.
d. Set the Motor Assembly aside and close the Latch
and Door on the Mounting Bracket. Align the
Mounting Bracket with the drilled holes.
3d
Mounting
Bracket
Drilled Holes
©2019 Johnson Outdoors Marine Electronics, Inc.
Drilled Holes
Deck of
Pontoon
Latch and
Door
Mounting
Bracket
Deck of
Mounting Holes
Pontoon
3c
Mounting
Bracket
Shaft
INSTALLATION
Mounting
Holes
Steering
Tension
Knob
Shaft
Latch and
Door
Steering
Tension
Knob
minnkotamotors.com | 9