Deploying The Motor; Removing For Transportation/Storage - MINN KOTA 1355954 Manuel Du Propriétaire

ADJUSTING THE DEPTH OF THE MOTOR

Deploying the Motor

1
a. Loosen the Adjustable Depth Collar.
b. Hold the Motor Shaft or Control Head firmly, and
loosen the Steering Tension Knob.
c. Gently lower the motor into the water.
d. Retighten the Adjustable Depth Collar. It should sit
just on top of the Mounting Bracket.
e. Retighten the Steering Tension Knob to the desired
steering tension.

REMOVING FOR TRANSPORTATION/STORAGE

1
a. Disconnect the motor from batteries by disconnecting
the Power Leads.
b. Loosen the Steering Tension Knob to open the Latch
and Door on the Mounting Bracket. Remove the
motor assembly from the Mounting Bracket.
c. Close the Latch and Door on the Mounting Bracket
and tighten the Steering Tension Knob so the Latch
and Door remain closed.
WARNING
The Control Head will create a pinch point if the Depth
Adjustment Knob is loosened and the motor Control Head
slides to the top of the Mounting Bracket. Grasp the Shaft
and prevent it from sliding all the way down to prevent the
pinch point. Grasp the Motor away from the area that may
come in contact with another area of the Motor to prevent
injury. Watch for pinch points when opening and closing the
Latch and Door.
18 | minnkotamotors.com
Motor Shaft
Mounting Bracket
1a
Power Leads
1b
Mounting Bracket
1c
Mounting Bracket
Control Head
Adjustable
Depth Collar
Steering
Tension Knob
Latch and
Door
Steering
Tension Knob
Motor Assembly
Latch and
Door
©2019 Johnson Outdoors Marine Electronics, Inc.