MINN KOTA 1810244 Mode D'emploi

The Quick Release Power Disconnect Plug is for Talon Shallow Water Anchors. This heavy-duty, waterproof connector features an all-
inclusive screw-lock design to disconnect power to the Talon when the Power Switch is "off."
Item /
Part # Description
Assembly
2 2377510 CONNECTOR-CABLE ASM, TALON
4 2370277 CAP, M-DUST, TALON CONNECTOR
6 2370278 CAP, F-DUST, TALON CONNECTOR
8 2305404 SHRINK TUBE-.374 ID X 1.0"
p
2374956 INSTRC. SHEET, CONNECTOR CABLE
TOOLS AND RESOURCES REQUIRED
• Utility Knife
• Needle Nose Pliers
• #2 Philips Screwdriver
• Heat Gun
INSTALLATION
1
WARNING
Make sure the Talon is not connected to a power source.
a. Before beginning any work on the Talon, completely
disconnect the Talon from power.
b. Remove the four #8-16 x 1.5" Plastite Screws
from the Right Motor Cover. Leave the two smaller
#8-32 x 1" Screws in place.
2
c. Remove the two 8-32 x 5/8" Screws from the Left
Motor Cover.
d. Remove the Left Motor Cover.
NOTICE:
Take note of wire routing before
proceeding.
©2020 Johnson Outdoors Marine Electronics, Inc.
QUICK RELEASE DISCONNECT PLUG
Qty.
1
1
2 2
1
3
1
NOTICE:
The Talon draws a small amount of residual
current from the battery even when not in use. Installing
the Quick Release Disconnect Plug, allows the Talon to be
easily disconnected for long term storage.
1b
Deployment
Notification
Alarm Wire
(green)
Negative Lead
(black)
Power Cable
Left Motor Left Motor
Cover Cover
Screws Screws
4 4
6 6
8 8
Plastite Plastite
Screws Screws
Fuse
Assembly
Positive Lead
(white)
Right Right
Motor Motor
Cover Cover
Right Motor Right Motor
minnkotamotors.com | 1
1810244
Cover Cover