Grundfos RCME Notice D'installation Et De Fonctionnement page 20

15.7.1 Display language (4.7.1)
Fig. 33 Display language
Select the display language of the CU 372.
Possible settings:
English
•
• German
• French
Dutch
•
Danish.
•
If the buttons are not touched for 15 minutes, the display will
return to the language previously selected.
Factory setting
The display language is English. It can be changed at start-up.
15.7.2 Units (4.7.2)
Select measuring units for the various parameters shown in the
display.
Fig. 34 Units
For the basic setting, choose between SI and imperial units.
It is also possible to select other units for the individual
parameters.
20
Setting range
Basic setting
Parameter
SI Imperial
Pressure
bar
3
Flow rate
m /h
3
Volume
m
Level
m
If units are changed from SI to imperial and vice
Note
versa, all individually set parameters are
changed to the basic setting in question.
Factory setting
The CU 372 has been factory-set to SI units.
15.7.3 Date and time (4.7.3)
Set the date and time and select how they are to be shown in the
display.
Fig. 35 Date and time
The clock has a built-in rechargeable power supply which can
supply the clock for up to 20 days if the power supply to the
CU 372 is interrupted.
If the clock has been without power for more than 20 days, it must
be set again.
Setting range
The date can be set as day, month and year. The time can be set
as a 24-hour clock showing hours and minutes.
There are three formats:
Examples of format
2013-03-21 11:49
21-03-2013 11:49
3/21/2013 11:49 am
Factory setting
Local time.
If the CU 372 has been without power for more
than 20 days since it left the factory, the clock
may have returned to the factory setting.
Note
Date and time may have been changed during the
setting of the CU 372.
There is no automatic changeover to and from
daylight-saving time.
Possible units
kPa, MPa, mbar, bar, m,
psi
psi
3 3
m /s, m /h, l/s, gpm,
gpm
3 3 3
yd /s, yd /min, yd /h
3 3
gal l, m , gal, yd
ft m, cm, ft, in